Small Triquetra Mold
These molds are for creating a small triquetra.
We're creating these molds as fast as possible and shipped to folks in the order they signed up for them via our waiting-list form.
Casting Mold Quick Reference
Fill Weight 100 g (3.5 oz)
The surface of the mold is non-porous, which means ZYP aerosol works best as the separator. You must prime the mold thoroughly with separator.
These molds have more mass than a lot of other casting molds. You may need to adjust the schedule for your mold and your kiln. Ramps need to be slower (especially on the anneal) than most typical preset fusing schedules. Raise the molds on kiln posts so that air can circulate underneath.
| Full Fuse Schedule - 90 COE | |||
|---|---|---|---|
| Step | Ramp | Temperature (F) | Hold Time (minutes) |
| 1 | 300 | 1100 | 20 |
| 2 | 100 | 1225 | 30 |
| 3 | 400 | 1465 | 10 |
| 4 | 9999 (AFAP) | 900 | 60 |
| 5 | 100 | 700 | off |
| Full Fuse Schedule - 96 COE | |||
|---|---|---|---|
| Step | Ramp | Temperature (F) | Hold Time (minutes) |
| 1 | 300 | 1100 | 20 |
| 2 | 100 | 1225 | 30 |
| 3 | 400 | 1450 | 10 |
| 4 | 9999 (AFAP) | 950 | 60 |
| 5 | 100 | 700 | off |